Porcelainplus The Keope porcelain tile specialist

There are several heating systems on the market for generating heat in a room. This is only one system

we have highlighted which shows a warmup system where a tile has been fixed in an unheated

conservatory onto a concrete floor using insulation panels, a heating matt and a quality Keope porcelain

tile.The tile fixer can do the whole job and an electrician will do the final wiring to ensure a fully

functional floor meets all standards .

We can supply you with all your needs and you can view the full range at www.warmup.co.uk

WARMUP INSULATION BOARD is a water resistant insulated tile backer board made of extruded

polystyrene, faced on both sides with a fibreglass mesh embedded into a thin cement polymer mortar.

These can be used as a structural tile backer board in the floor. It will withstand a load of 30 tonnes

per square metre and is ideal for use with underfloor heating as it pushes the heat into the room, by not

allowing heat to penetrate down into the concrete substrate below. As a wall tile backer board, tiles

can be fixed directly on to the surface without prior preparation and, being totally waterproof, which is

ideal for use in bathrooms or showers.

Warmup Insulation Boards will save you money when used in conjunction with undertile heating by

acting as a very efficient thermal barrier. It reflects the heat upwards into the floor tile instead of

allowing heat to warm up the concrete slab below. By using Warmup Insulation Board you will find that

after switching on your heating, your floor tiles will warm up in about 10-15 minutes. Without insulation

boards it could take anything from 2-3 hours, or more.

Undertile Matting System

The Professional Undertile Heating System from Warmup is an uncomplicated concept specifically designed for the

professional user: the electrical heating cable is attached to a tough fibreglass mesh, rolled out before tiling, and

connected to a programmable thermostat.

So luxurious, yet so easy...

Economical and environmentally friendly

Depending on the insulation qualities of the floor, Professional Matting as little as 1/2p per square metre per hour to

runusing the clean power of electricity. Plus, a Professional Matting System heated floor creates only the minimum

of air currents, unlike radiators, which can create dust marks by their 'chimney' effect. In fact, the temperature

difference between floor and ceiling in an average room is only 2C.

So simple to install

Professional Matting System's dual core heating element, with only one power lead to wire, is easy to install in just

a matter of hours, without raising floor levels. The cable is attached in a series of loops to thin but tough mats, to

fit rooms from 1.5m.

Maintenance free

Professional Matting System has no moving parts to service or go wrong. Once, it is laid and tiled over, set the

thermostat and forget it! The only reminder comes each morning when you step into a deliciously warm floor.

Unseen luxury

As well as freeing up wall space normally taken up by radiators, Professional Matting System is completely invisible

so that all that is on view is a discreet thermostat.

24 hour support

Installing Professional Matting System is incredibly easy but we still offer 24 hour support to every customer to

answer general questions and one-off queries concerning unusual situations